fadercore_-_vlr-3x8but
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
fadercore_-_vlr-3x8but [2014/07/27 22:10] – novski | fadercore_-_vlr-3x8but [2014/07/28 07:31] (current) – novski | ||
---|---|---|---|
Line 44: | Line 44: | ||
Project Order Basket on Mouser: [[http:// | Project Order Basket on Mouser: [[http:// | ||
- | The PCB is available under: [[]] | + | The PCB is available under: [[https:// |
Line 62: | Line 62: | ||
==== Test it in MIOS ==== | ==== Test it in MIOS ==== | ||
- | + | \\ | |
- | To make it work with MIOS .NGC File we need to know how the shift-registers are connected. | + | To make it work with MIOS .NGC File we need to know how the shift-registers are connected.\\ |
+ | \\ | ||
**Inputs: | **Inputs: | ||
- | 1# Encoder | + | 1# Switch Columns |
- | 2# Encoder | + | \\ |
- | 3# Encoder Button | + | |
**Outputs: | **Outputs: | ||
- | 1# RED Shaft LED 1-8\\ | + | 1# ROW Outputs |
- | 2# GREEN shaft LED 1-8\\ | + | 2# RED LEDs |
- | 3# BLUE shaft LED | + | 3# GREEN LEDs |
- | 4# LED Ring Row | + | 4# BLUE LEDs 1-8\\ |
- | 5# LED Ring Selct 1-8\\ | + | \\ |
- | 6# LED Ring Select 9-11\\ | + | Assuming that the VLR-3x8But |
- | + | ||
- | Assuming that the VLR-8Enc is the first device on the chain of J8/9 we need to configure it like this: | + | |
\\ | \\ | ||
RESET_HW\\ | RESET_HW\\ | ||
Line 131: | Line 127: | ||
\\ | \\ | ||
Im using my VLR-8oDisp board to show the Values of every item. You can change it to any other type of Display-setting... lcd_pos=6: | Im using my VLR-8oDisp board to show the Values of every item. You can change it to any other type of Display-setting... lcd_pos=6: | ||
+ | |||
+ | For any Comment or Question: Forum Thread??? |
fadercore_-_vlr-3x8but.1406499015.txt.gz · Last modified: 2014/07/27 22:10 by novski