mbqg_fp
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| mbqg_fp [2021/01/31 16:21] – smithy | mbqg_fp [2024/02/02 15:01] (current) – [MIDIbox Quad Genesis: Front Panel] smithy | ||
|---|---|---|---|
| Line 4: | Line 4: | ||
| To build the front panel of MIDIbox Quad Genesis, you will need (details on each part below): | To build the front panel of MIDIbox Quad Genesis, you will need (details on each part below): | ||
| - | * An aluminum front panel **OR** 3D Printed Front Panel (See Below) | + | * An aluminum front panel |
| * A PCB to hold all the buttons, LEDs, encoders, etc., and of course all these electronic components themselves | * A PCB to hold all the buttons, LEDs, encoders, etc., and of course all these electronic components themselves | ||
| * A bunch of 3D printed transparent button caps | * A bunch of 3D printed transparent button caps | ||
mbqg_fp.1612110064.txt.gz · Last modified: 2021/01/31 16:21 by smithy