Differences

This shows you the differences between two versions of the page.

--- seqv4plus_enc-plate [2017/09/12 20:06] – [Assembly] latigid_on
+++ seqv4plus_enc-plate [2018/12/18 09:35] (current) – [BOM v1.0] latigid_on
@@ Line 33: / Line 33: @@
 ===== BOM v1.0 =====
+**Please find the current BOM on [[http://midiphy.com]]. The table below is depreciated and will not be updated.**
 ^Type     ^Qty	^Value	   ^Package	^Parts^Mouser^Reichelt^Conrad^Other^Notes^
@@ Line 40: / Line 41: @@
 |         |8    |STEC12|         | | |STEC12E08      |      | | |
 ^Headers^^^^^^^^^^
-|         |3    |1*10                  |through-board |MDF7-10S-2.54DSA(55)  |        |      |     | | |
+|         |3    |1*10                  |through-board | |MDF7-10S-2.54DSA(55)        |      |     | | |
 ^Hardware^^^^^^^^^^
 |         |2    |M2 washer |3mm?       |             |        |      |     | | |
@@ Line 55: / Line 56: @@
 Start with the eight encoders and diodes. Important to note:
-  * There is <3mm vertical distance between the stacked PCB sets. If diode or encoder legs are too long, they may short out the components below. I need to check the assembly. It might be that all parts on the ENC-PLATE PCB are soldered from the top and the legs protruding through are trimmed flush on the underside.
+  * There is less than 3mm vertical distance between the stacked PCB sets. If diode or encoder legs are too long, they may short out the components below. I need to check the assembly. It might be that all parts on the ENC-PLATE PCB are soldered from the top and the legs protruding through are trimmed flush on the underside.
 Once the diodes and encoders are okay, line up the headers, using a [[seqv4plus_le_mec|le MEC]] board and optionally some of the mounting points. Once you are happy, solder the three 1*10 male pin headers on the lower PCB, and only then fix the through-board female headers on the upper PCB.