I had painted the wooden case for my controller, and it finished drying today. I used "Dekorwachs", it needed a long time to dry completly. The water- and dirt-repelling properties of wax are really good. All in all I am quite content with my build, still there are a few quirks withthe case, like minor gaps due to the wood (spruce-wood tends to...
0
geth's-building-stuff-Blog
Hi!As I only started blogging, but work on this controller for about a month (plus some planning time), I have to close up to my current status, which I will do today.So the controller is called mothership, because it is rather big 
. It will be around a metre to half a metre to fifteen centimetres.It holds controls for four decks inclusive...
. It will be around a metre to half a metre to fifteen centimetres.It holds controls for four decks inclusive...
My next step was to build a working core (lpc17) with some DINs and DOUTs. After some troubles ... I succeded.I am really astonished, this device is the least troublesome device I have encountered so far. No extra drivers, just plug and play, and the controller can be unlugged and reconnected while traktor is running, no crash, not even a lag!By the w...
Hi,this is my blog about how I am going to build a Traktor-Controller.Well, and if this one turns out good, or at least not too bad, building more controllers.I am playing around with traktor for about two years, and I was never really satisfied with the layout of the (traktor, or other midi-) controllers one could buy.Thus, when I found the ucapps site a...
