theskeletonboy

Thanks everyone for you responses! JJonas i will check that out. yeah sometimes i click buttons or move the encoder and it jumps the correct single value and sometimes it jumps anywhere from 2-5 values, totally randomly. I can take a look at the source code with your forum post. Katch - the swap test sounds like a good idea, I have done that before with cables and other studio equipment... ill report back. From the time i've had it its always been in a smoke free studio, rarely used, not plugged in when stored. The circuit boards are pretty clean, but i will take a good look around on the board to see if there's any bad solders or dust. From when i've cracked it open it seemed clean to me. I'll post photos later. Thanks! - Skele

I am the owner of a White sammichSID kit that i bought from another user on the flea market a while back and I've recently been playing with the synth again. I want to make sure its in perfect working order, and I have discovered that it is not. I have two problems with its functions: 1. When I received it, it was jumping values with the encoder as well as the up and down arrows. Is there a fix for that? 2. I also have a problem with the right chip in mine, sometimes it cuts out completely. Turning it off and back on again makes the chip start working again, but i've noticed that it has a slightly different tone than my other chip, despite being the same series. I'm capable of repairing this myself, I'm just not sure where to start to fix these issues. Can you suggest anything?

I am throwing my sammichSID up for sale. Heres a link to a craigslist post I made about it: http://losangeles.craigslist.org/wst/msg/5207645845.html I want 500USD$ for it, Free shipping. It comes with a TRS breakout cable for stereo output and it comes with a 12V US 120v plug CCTV power supply. Its in fully assembled and functioning condition. The encoder jumps around a bit but not an issue if you're using it in the studio.

pm'ed