latigid on
-
Posts
2,516 -
Joined
-
Last visited
-
Days Won
147
Content Type
Profiles
Forums
Blogs
Gallery
Image Comments posted by latigid on
-
-
It works with some creative pad arranging!
But I agree, the D6 buttons are pretty good (I gave a few reasons in the V4L thread). In saying that they are quite tall (better for raised front panels though) and do have a bit of slop when pressed, so another option's not a bad thing.
-
Sadly no difference as the D6 pads are on square. I've got something workable just moving the other switch up
1.51.6mm, should be fine! -
6mm ones with pin spacing of 6.5/4.5mm?
Not sure if the fab will like the overlapping drill hits...
Do you have an example layout or know of a board house that will do them?
-
I can try, what's your preference? Anything but TL1100, they go dodgy after a few years.
See here also:
-
9 minutes ago, Hawkeye said:
That looks fine! :-)
Many greets,
Peter
Many thanks!
-
-
Quite strange sockets; any reason for this?
-
Cheers, and what step-up converter was used? Many thanks
-
Sexy stuff! What power supply are you using and did you use an internal SD card only?
-
The above layout had a few errors including mislabelling of the +/-15V supply and a wrongly routed trace around R2/3D. These were spotted before fabrication.
-
Wow, epic panel!
-
Good lord! Best of luck with this mate!
-
A Christmas tree! Nice!
-
IT'S....................................ALIVE! :D
-
What does the one on the right do?
:wink:
Pretty design all around!
-
WTF is this?/
Oh, I see :)
-
KAN HAZ CIRCUT DIAGRAM 4 DIS??
-
weeeeeeeeeeeeeeeeeee heeeeeeeeeeeeeeeeeeeee!
:)
nice1
-
very clever, the alignment still works? Or is some filing/shaving involved?
-
WOW! :sorcerer:
stack.jpg
in Schematics and PCBs
1Posted
Control + AOUT + DOUT stacked.