LoneStar Posted May 31, 2009 Report Share Posted May 31, 2009 Greetings,I'm using the MIDIO128 for MIDI-controlled switching purposes using 4066 (quad cmos switches) controlled by DOUT.I can configure the MIDI-In behavior to my liking in the .ini file (Note on -> DOUT pin 5V, Note off -> DOUT pin 0V etc).In the given configuration, any DOUT pin follows the state of the corresponding DIN pin (given it is enabled in the ini file).How could I change the DIN-DOUT forwarding from edge-driven to toggle, so I can use pushbuttons to switch the DOUT pins on/off?Regards,LoneStar Quote Link to comment Share on other sites More sharing options...
stryd_one Posted June 1, 2009 Report Share Posted June 1, 2009 Welcome aboard LoneStar :)Try @Toggle in the ini file :) Quote Link to comment Share on other sites More sharing options...
LoneStar Posted June 1, 2009 Author Report Share Posted June 1, 2009 Welcome aboard LoneStar :)Try @Toggle in the ini file :)Thanks for the welcome :)Unfortunately, the @Toggle in the ini file only determines how the DOUT pins react upon incoming midi messages.My problem is, how do I get the same on the DIN-DOUT forwarding? All there is is an option to turn forwardingon/off, when on the DOUT pins simply follow the DIN pins. What I want it to do is a DIN pin toggling the correspondingDOUT pin, as in DIN low -> DOUT high, DIN high again -> DOUT stays high, next time DIN low -> DOUT lowI reckon I'll have to change the DIN handler code for that. Unfortunately my programming skills are practically not present. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.