Jump to content

encoders with LED rings?


the19thbear
 Share

Recommended Posts

you could make 2Boards... the buttom board - with the encoder on it and its Shiftregisters and resistors... and a top board with the Leds on it and its Shiftregisters and Resistors...---and then drill a hole in the LED boards, for the Encoder shaft... this make the DIY Board-design (if single sided is the only way...) and so on much easier...

The BCRs are SMD LEDs with some transparent Plastik-shafts on it... plastic waste... when you use 1mm standard LEDs and drill holes for that in your Front-Panel - Then this looks the same way...

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...