AINx4 problem

[Spirit]

Hello again.

I have connect 20 Fader to a AINx4

Maby a little strange but it Used pin 13 to 32.

But if i slide the fader on pin 32 in Does not Respont.

i if slide the fader on pin 31 it react only it Send 2 notes.

And to make a Layout from Pin 32 to 13 it look like this.

R = Reponding only it sends 2notes

N = Not responding

N-R-R-N-R-N-N-R - N-R-R-N-R-N-N-R - N-R-R-N

As you see its the same Pattern

But what did i do Wrong?

Kind regards, Emile ballard

[Janis1279]

Hi,

If you used MB64 setup

connection diagramm looks like :

http://www.ucapps.de...p/auaimbctg.pdf

and asm setup file part looks like:

; Setup File of TK's MIDIbox64

;

; Number of connected pots

; Allowed values: 1-64

#define DEFAULT_NUMBER_POTS	20    ; number of connected pots

;

; Multiplexers (AINX4 modules) connected? -> set this value to 1

; No multiplexer connected= -> set this value to 0, allowed number of pots in this case: 1-8

#define DEFAULT_MUX_ENABLED 	1	; enable multiplexers

;

Regards,

Janis

[Spirit]

Hi thanks for the reply i will look in to it.

But i just connect the other AINx4 module and that one just works fine.

i also connected the wires this time from 1 to 20.

so if i get my pots i will try the other AINx4 module again and see what will happin.

Thank anyway, and yes i made a MB64.

Kind regards, emile ballard

[unuldinei]

1 - Check the CORE with 8 unmuxed pots.If it is OK then ... 2 - Check the board AIN4 , it seems is like a defect on it .

[Spirit]

Thats for the extra thinking.

but as i sad before the Second AINx4 Module work like a Sharm.

but i look a little closer to the other AINx4 module and i Noticed one BIG soldering fault and a Little one.

so hopefully that will solve my problem.

but first i'm waiting on my Nice Digitast Buttons.

then the Pots will come ;-)

Thanks for everything, Spirit