Jump to content

connecting stm32F4 in mios how to


electrodancer
 Share

Recommended Posts

You dont need to install a driver.

The driver you downloaded is the GM5 driver and in the description is also written that the STM is not supported . You can use it as alternative to the legacy ("onboard") driver for other cores.

After you connect the Core Module, wait until your operating system has found the interface,

the driver will be installed automatically.

Look in your device manager if some new hardware (usb audio device) is detected. 

If nothing happens then there is something wrong. 

Edited by Marxon
Link to comment
Share on other sites

Sorry there is no possibility.

It was discussed in past:

 

The STM32F401 is very limited, most major applications (such as MBNG, MBSEQ) wouldn't fit into the small flash memory.

 

However, before you throw it away, you could send it to me so that I can provide (and test) a MIOS32 variant for this chip for the case that somebody want's to use it for less complex applications like MIDIO128

 

Best Regards, Thorsten.

 

Where did you ordered your board?

Can you send a link?

Link to comment
Share on other sites

As said the STM is not supported but it is recommended for other cores running MIOS32 applications (including the LPC)

because it has a higher robustness of SysEx transfers and better a performance then the windows legacy driver.

The GM5 driver also gives multi client capabilities.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...