Jump to content

Wilba controls mixed up


oozitron
 Share

Recommended Posts

EDIT - found my error...  my computer's "Q" key is flakey and my config file was named 'MBSE_HW.V4'   :rolleyes:

Things are working good now  :smile:

----------------------------------------------

 

My SEQ4 is almost alive :-)

 

I hooked up the (Wilba) control panel and the controls seem to be mixed:

Encoder 1 --> STEP mode

Encoder 3 --> turns SCRUB on/off

Encoder 4 --> moves cursor across screen

Encoders 13/14/15/16 --> change notes in positions 4, 3, 2 & 1 respectively

Data Wheel --> changes note in position 6

 

The buttons do not do the expected things; many seem to do nothing.

 

I do *not* have the LEDs in place yet (does that matter?)

 

Do I maybe have my connector cable wired backwards?

 

I do not get an SD card read error.

 

Any suggestions?  thanks,

Drew

Edited by oozitron
Link to comment
Share on other sites

i ran into a somewhat similar issues a few weeks back w/ my new seq4. i would try another SD card, formatted freshly to fat/fat32 w/ the config file. mine was not showing an error on the mb during load but the sd card itself was corrupted when checking via a computer.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...