Program Bootloader into STM32F4 with openocd?

[audiomobster]

Hi there,

I have no virtualized Windows so I am trying to flash the bootloader with openocd:

openocd -f stm32f4discovery.cfg -c "program project.bin exit"

I get following output:

Open On-Chip Debugger 0.9.0 (2015-11-28-15:54)
Licensed under GNU GPL v2
For bug reports, read
    http://openocd.org/doc/doxygen/bugs.html
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
adapter speed: 2000 kHz
adapter_nsrst_delay: 100
none separate
srst_only separate srst_nogate srst_open_drain connect_deassert_srst
Info : Unable to match requested speed 2000 kHz, using 1800 kHz
Info : Unable to match requested speed 2000 kHz, using 1800 kHz
Info : clock speed 1800 kHz
Info : STLINK v2 JTAG v14 API v2 SWIM v0 VID 0x0483 PID 0x3748
Info : using stlink api v2
Info : Target voltage: 2.891327
Info : stm32f4x.cpu: hardware has 6 breakpoints, 4 watchpoints
target state: halted
target halted due to debug-request, current mode: Thread
xPSR: 0x01000000 pc: 0x0800637c msp: 0x20000c78
** Programming Started **
auto erase enabled
Info : device id = 0x10036413
Info : flash size = 1024kbytes
Warn : no flash bank found for address 0
wrote 0 bytes from file project.bin in 0.001464s (0.000 KiB/s)
** Programming Finished **
shutdown command invoked

I guess I need an offset, but how large?

Thanks and best regards,

Uli

The following seems to work:

openocd -f stm32f4discovery.cfg -c "program project.bin exit 0x08000000"

At least it doesn't throw an error.

But it shows up as "Van Ooijen Technische Informatica". Isn't this weird?

Edited November 28, 2015 by audiomobster