NMNN

CV and Gate/Trigger/ Setup - AOUT port no dual gates out

3 posts in this topic

Lately I've been trying to use the extra functions of the CV-Gate out, specifically the possibility to send velocity with key values.



From the manual:

Quote

Note 9 Key Value -> CV Out #1, Velocity -> CV Out #2, Gate #1 and #2 triggered

Note 10 Key Value -> CV Out #3, Velocity -> CV Out #4, Gate #3 and #4 triggered

etc, etc, etc

 


When I use AOUT - channel 9 I get key and velocity from the first two CV's out, as expected. But only gate #1 is triggering.

When I switch to AOUT - channel 10, I get key and velocity from the second pair of CV's out: 3 and 4. And gate #2 is firing.

What I expect is when I use AOUT - channel 9, is to get CV's from 1 and 2, and gates on #1 and #2.

This is consistent through the whole range of outputs. All the other functions work exactly as expected, the drum gates and the clocks nothing wrong.


I found this advise:

And I've scanned through the entire config, but pretty much everything is standard. I use the Wilba Front panel with the AOUT-NG with the DOUT. Here is my HW-V4: https://pastebin.com/M9aXWjEx

Am I making a mistake assiging SR's? Or is it something else I'm missing?



 



Thanks!

 

 

Edited by NMNN
markup

Share this post


Link to post
Share on other sites

Helo! Same problem, Wilba front panel two, last update but that's work well like that :

Note 9 Key Value -> CV Out #1, Velocity -> CV Out #2, Gate #1 triggered    

Note 10 Key Value -> CV Out #3, Velocity -> CV Out #4, Gate #2 triggered

Note 11 Key Value -> CV Out #5, Velocity -> CV Out #6, Gate #3 triggered  

Note 12 Key Value -> CV Out #7, Velocity -> CV Out #8, Gate #4 triggered  

Share this post


Link to post
Share on other sites

This was a translation error in the code, it's fixed now (and enhanced by a new feature! :)

http://www.ucapps.de/mios32/midibox_seq_v4_095_pre12.zip

   o AOUT: Channel 9..12/13..15 now set the gate pins #1/3/5/7 as documented (previously it was #1/2/3/4 due to a code translation error)
     New: gate pins #2/4/6/8 are now set whenever the velocity is >100.
     This way the pins can be used as an accent trigger

Best Regards, Thorsten.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now