Jump to content

CORE_STM32F4 Module, LCD, and fire


Wapata
 Share

Recommended Posts

So... It take way too much time to start using eagle. What a nightmare for a such simple board:

LCDtoRibbon.png.7483de79f2d570858294f574

Note that i havent check the reverse/mirror pin thing yet because I have a question first: how to make the upper solder pads to touch the border of the board ? This way it will be possible to solder this board to a 90° angle to the LCD with no wire.
And then I will find how to add the ribbon connector schematic..

Link to comment
Share on other sites

Maybe you can get it to a single layer by routing through the SIP header. 

For pads to the edge, you could consider a castellated pad/via. Normally the fab will charge extra for it. I'm not sure if it's a good idea mechanically; the simple pin header would be stronger. Or maybe I don't understand your idea.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...