gm02froe Posted October 15, 2005 Report Share Posted October 15, 2005 Hi I found the following discrepancy in the documentation for the core:http://www.ucapps.de/mbhp_core.htmlit states under available ports J2:....In both cases the voltage regulator (IC2) should not be connected, also the rest of the voltage stabilization circuit between J1 and J2 (X1, C5, C6) can be left out...according to this diagram:http://www.ucapps.de/mbhp/mbhp_core.pdfIC2 is the optocupler.same thing further down under "used components".I assume the labeling in the core diagram is wrong, right? I am a newbee in electronics and just want to be sure, cause I want to power my two cores with 5V supplies.best regardsmartin Quote Link to comment Share on other sites More sharing options...
moebius Posted October 15, 2005 Report Share Posted October 15, 2005 Yes,you found an error! As TK says, schematics are always the reference, so the core page has IC2 and IC3 mixed up.Bye, Moebius Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.