insectteam

Hi! I have a program that communicates only system exclusive messages. Is it possible to learn the buttons connected to the DIN to be able to send this messages and that the diode connected to the DOUT respond to feedback messages? Sample code sent when switching on ( from midi-ox ): SYSX: F0 7F 7F 02 01 01 31 2E 30 30 30 00 32 31 2E 31 F7 and sample code sent when switching off : SYSX: F0 7F 7F 02 01 0A 30 2E 30 30 30 00 32 31 2E 31 F7 Regards Daniel P.S. or maybe can only LED's connected to the DOUT have feedback on/off receiving SysEx from the program ?

Thanks ... 3x 100uF near pots and everything workong :)

thx for reply ... but this part of config file is O.K. I don't know what wrong ... i must search everything in soft - hardware is 100% correctly.

Hi ! Sorry for my long answer ... I change my PSU and trouble is the same :( , and faders are wired correctly ... when I change software from MB64E to MB64 everything is ok. Maybe my config file is wrong ??

Hello Everyone ! I finished my second midibox today - MIDIBOX64e - my first is MIDIBOX64. I have : 4 encoders 16 buttons 16 faders I noticed that fadres still sends data if they are on break down - just when all be upraised send data is stopped this normal and how to do away this ?? Cheers Daniel

That is this !!!! Thanks so much ... ...I thank You very much ...I do not know how to show grateful oneself Best Regards, Daniel

... no , it's not a tractor :) ... this for me valuable tip, but my skill of programming is very low ... and I don't know what and how ...

Hi everyone !!! At now I have next problem - can I change encoder mode 40 +/- 1 ( possible value on output - 3F and 41 ) to values 40 and 41 ?? where I can this change and how ?? ... I apologize for my weak English also Daniel P.S or maybe exists different method continuous sending value 40 if encoder is turned left, and value 41 if encoder is turned right

i have all programs to make a hex file ... and I make it :) , but with incorrect configuration I'll try to do this correct :) THX Daniel

Hi everyone ! I need help make a hex file with my MB16E setup. What I need : - 8 encoders - 24 faders - no buttons ( no menu buttons too ) I have core , dinx2 and AIN ... I don't know how make a hex file from setup.asm file - i try to do this but still nothing good ... Maybe anybody make for me this setup hex file Thanks Daniel

Hi ! Thanx for Your answer. At now my MidiBox working :) !!! Everything is so simple - my sugestion for every one - if core don't comunicate with PC ( LPT module ) - maybe it's problem with Yamaha driver ( I have this ) - please install Roland driver - that is better !!! P.S I'm from Poland

Hi All ! I'm new on this site and on start i apollogize for my english. It's my first project on PIC processor and I need help about program midibox 64 What I have at now: - PIC 18F452 - PIC programmer - MBHP v3 - LTC module - AIN module - LCD module Because my english is quite well please tell me step by step what I must to do to start my MIDIbox. For example : " - on a start You must program Your PIC - burn in *.hex file ( *.hex it's name of file ) - second You must ......." Finally I going to do : 24 faders and 96 buttons + LCD Please help me ..... Thanx Daniel