cogsmech

Chatroom?

Don't know if this helps. Mios hooked to core through us 122l mios to core.JPG mios to core.JPG

yes i'm sure. I just tried my us 122l and the input matched the output

I tried a different midi cable and it's the same

Is this what you wanted? Input monitor is blank. mios out.JPG mios out.JPG

Ok, got it now thanks. I really am a novice mios.JPG mios.JPG

It seems the file is too large to upload.

Hello my friend, honestly, I'm feeling totally lost. I don't know hnow to send a screenshot of mios studio, however, the port routing appears to be correct if in goes to in, and out to out. If not I don't know how to change them. Yes I have an actual cable going from in to out on the midisport, and when I send the Midio128 hex.,I see stuff in the output monitor and not the input monitor. I don't see what could cause an "echo" as you describe. I don't know if it helps, but I have recieved ok checksums. Thanks!!

Still no luck. Should I get note messages after only uploading the midio 128 hex, or does it need the separate ini. file? In which case shouldn't I be more concerned with mios studio than midiox? Thanks!!!

I'm trying different low level output buffers and delays working with the loopback, trying to get the messages to match. Sometimes I am getting long strains of control messages in blue and sometimes have to disconnect the midi cable to stop it.

Hello and happy holidays!! I'm back and still no midi :( I bought a midisport 1x1, tried several drivers, and the communications still don't appear to match. Actually it seems worse. When I send an upload or sysex, I can't tell if it's working.What am I looking for in midiox and mios studio as far as messages from the midibox? I tried sending the midio 128 syx through the loop back and I'm not getting matched input and output. I'm feeling kinda lost. I even tried using another computer. Please help!!!

Sorry I didn't see the link. Thanks again for your time and I shall report back :)

I haven't seen a "blacklist"

Would a regular us 122 work?

I just started my quest for midi again and I don't know if it'll help but I have +5v on the out midi port from center (ground?)to both of the terminals in question and nothing at all on the in port. Thanks!!