Prog Chng messages cause erratic behaviour

[banneduser]

I have built a Logic environment to change patches on my Line6 POD via Program Change #'s - it all works fine with this. ;D

I have taught the MBox 64 the same Program Change #'s but I get erratic results. The value on the buttons is set to TOGGLE as ON and ON/OFF don't work as 1 hit commands. When I hit the button assigned to Patch 1A (Program Change 1) it MAY go there - otherwise it will put the POD into Manual Mode (which is actually Program Change 0!).

If I hit the button assigned to 1A again it will come out of Manual Mode and return to 1A. If I hit the button assigned to 1B (Program Change 2) it may or may not go there - if it doesn't it will go to Manual Mode again ... this does not occur when I control the POD from Logic! ???

How should I program the MBox64 so that the button will send ONLY the Program Change # assigned to it and not sometimes send Program Change 0! :-[

Pete

[banneduser]

Solved it - turns out Ian Hurlock had wired his MBox so that the buttons I wa using were wired to pots ... now working with buttons only and it's all dandy!