Vinyljunkie Posted May 9, 2008 Report Share Posted May 9, 2008 bin grad an einem Projekt zur syncronisierung von nanoloop.dazu brauch ich halt nen "gbsynckabel" -> http://homepage.mac.com/ozonepool/diy/nmsa/kann ich den Microcontroller via midiox programmieren???es gibt noch ne seite für das gb kabel ->http://wiki.littlesounddj.com/KeyboardInterface?v=7efich hab da das Serial out kabel an die platine gelötet und natürlich auch 5v und gnd, nu die frage ob das serial out das richtige ist oder lieber serial in oder clock ??? Quote Link to comment Share on other sites More sharing options...
seppoman Posted May 9, 2008 Report Share Posted May 9, 2008 Per Midi kannst Du den Tiny leider nicht programmieren. Man braucht dazu einen AVR ISP. Falls Du noch einen PC mit Parallelport hast, kann man sowas einfach und billig selbst zusammenlöten - einfach mal AVR ISP googeln - z.B. http://www.pitsch.de/stuff/mmc2iec/avrisp.htm das kostet keine 2 Euro, die SUB-D Buchse ist da schon das teuerste dran. Es gibt auch ISPs mit USB, die muß man aber kaufen. Kostet ca. 25-30 Euro, für nur mal einen Chip also zu viel. Quote Link to comment Share on other sites More sharing options...
Vinyljunkie Posted May 10, 2008 Author Report Share Posted May 10, 2008 muhaha langsam hab ich kein bock mehr auf das ganze gelöte :o Quote Link to comment Share on other sites More sharing options...
Pascal Posted May 10, 2008 Report Share Posted May 10, 2008 Oder jemamd suchen der einen ISP hat und die Attiny´s beschreiben kann. Wäre das einfachste würde ich fast sagen ;-) Quote Link to comment Share on other sites More sharing options...
Vinyljunkie Posted May 10, 2008 Author Report Share Posted May 10, 2008 ich hab mir erstmal die teile bestellt hoffe ich bekomm das teil bis zum 31.5 zu laufen Quote Link to comment Share on other sites More sharing options...
Vinyljunkie Posted May 15, 2008 Author Report Share Posted May 15, 2008 so ich habe fertig, aber das pony programmier tool zeigt mir immer nen fehler an.Device missing or unknown device :'( Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.