mikee Posted September 30, 2009 Report Share Posted September 30, 2009 Hi folks, got my first MB app off the ground at last.Threw my stuff together, dying to do a few pot-tests and play around with Ableton. Expected many hours of tracing obscure dry joints and dead mice in the works as i never used a fancy printed board - just a plain non-copper perf board, but all worked extremely well indeed. My compliments to the Main Man.I intend to throw many more switches onto the board, 32 are too few. I will go up to 128 switches.Don't need leds - i can see what's happening on my monitor.Cannot increase pot above 64 without second 16f452, but 64 is loads for now.I burnt the chip, then uploaded setup hex file then after that i uploaded Mios, all via MIDI of course. I expected it to fail beacuse the write-ups say Mios first, then app setup second. Anyway, it worked a treat!!!Sitting at my desk surrounded by a huge rat's nest, feeling good.Psu runs stone cold. Its an old 12V supply from a PC100, and I whacked a couple of op-amps and a few power transistors to give me 5V. I really should reduce the initial supply to about 7v. But what can one do?I liked the little pot-levels on the display!See ya all again folks - keep on boxin' Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.