midiphy SEQ v4+
We're just about ready for launch of the new SEQ v4+. This thread serves as a proper introduction, you can also ask questions on hardware etc.
I first became aware of the SEQ around 2008. This was about the time of the migration point of V3 to V4 and the Wilba design. I finally
Hello, This is no. #4! ;)
Inside the beast:
Note , power/USB connection is not based on Micro-match here cause I used a first version wCore I already own.
So this one is little bit customised.
The MEC switches:
I used 5GTH920+1LS096-15.0 instead of 3FTH9+1S11-16.0. +
In this series, without smd led model accept regular 3mm led. The led is easy to install. The 1LS caps is made for that too.
Like for the 3FTH9 model, led must be bent like t
