midiphy SEQ v4+
We're just about ready for launch of the new SEQ v4+. This thread serves as a proper introduction, you can also ask questions on hardware etc.
I first became aware of the SEQ around 2008. This was about the time of the migration point of V3 to V4 and the Wilba design. I finally
I finally installed the two OLED which were missed, it's clearly better than regular LCD.
I made some wood sides too, in a very hard African wood which has blue veins , I stained in white("lasure" in french not sure of the English word).
This is more white in the daylight, outside. Here the DXF file, A CNC is necessary.
Yellow is internal cur at 5mm depth.
Green is internal cut at 3mm depth.
Red is external, depends on the desired thickness.
White is holes.
Blue is inte
