Adding CS-line to AINSER8
Hey people,
I'd like to add one or two chip-selects for the AINSER8. I've already made a few changes to the firmware but it's not working yet.
Under modules I've edited the ainser.c:
{
switch( module ) {
case 0: return MIOS32_SPI_RC_PinSet(AINSER_SPI, AINSER_SPI_RC_PIN_MODULE1, value); // spi, rc_pin, pin_value
case 1: return MIOS32_SPI_RC_PinSet(AINSER_SPI, AINSER_SPI_RC_PIN_MODULE2, value); // spi, rc_pin, pin_value
case 2: return MIOS32_SPI_RC_PinSet(AINSER_SPI, AINS
No but I followed up the logic in the code above:
// Which RC pin of the SPI port should be used for the first module
// allowed values: 0 or 1 for SPI0 (J16:RC1, J16:RC2), 0 for SPI1 (J8/9:RC), 0 or 1 for SPI2 (J19:RC1, J19:RC2)
#ifndef AINSER_SPI_RC_PIN_MODULE1
#define AINSER_SPI_RC_PIN_MODULE1 0
#endif
// Which RC pin of the SPI port should be used for the second module
// allowed values: 0 or 1 for SPI0 (J16:RC1, J16:RC2), 0 for SPI1 (J8/9:RC), 0 or 1 for SPI2 (J19:RC1, J19:RC2)
#ifndef