First build of MB6582

[Drakon]

Hello everyone. I'm new to the forum and I'm currently building an MB6582 for the first time. I have almost all the components in place, but I have a question for more experienced users: could you take a look and see if everything is OK before I connect the power supply and start testing? I decided to use the power supply option "E" from this thread:

So, the changes are:
- no B1 rectifier installed
- no C14 and C13 installed
- C3 is 10uF instead of 2200uF (and here I don't know what the voltage of this 10uF capacitor should be)
- V4 is a Recom R78B5.0-1.5
- V1 is a 7809 - as I understand from the documentation, if I only use the 6582, I don't need to put a 9V switching regulator here (Recom R-78C9.0-1.0?)
- pin 2 and pin 3 of J71 are connected by a jumper
- pin 2 and pin 3 of J72 are connected by a jumper
- pin 1 and pin 2 of J73 and pin 2 of J74 are connected by a cable under the board
- jumpers installed at J1_SIDx and J2_SIDx in the 9V position

Am I good to go further?

Don't worry about the dirty board; this is before cleaning.

 

Many thanks in advance!