durchgedreht Posted November 8, 2006 Report Share Posted November 8, 2006 Hi,I'm building a Core Modul on the Design on T. Close v3.The Midi Out has strange(?) 10V. Seems incorrect to me, but I'm not in Midi-Specification. The Voltage supply of the Microcontroller and smaller Chip seems korrect (5V at all points in the introduction).Any Idea?Thx,DennisUpdate:Seems to be my fault: I just was on AC not DC. With DC I get 5V+ on both outer Pins to the Groud Pin (middle). This should be correct, or?Additional Info:I'm just before loading up the syx file via midi into my bootloader and don't want to blow up my [expensive] soundcard. I even ordered a cheap Midi IO Cable to go for sure now. I can use it anyway for Laptop+Synths. Quote Link to comment Share on other sites More sharing options...
stryd_one Posted November 8, 2006 Report Share Posted November 8, 2006 5V is fine, go for it!Additional info: I take no responsibility if I am wrong and your PC blows up! hehehe Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.