Midi Out (J12 Ground and pin near J13) has 10V ????

[durchgedreht]

Hi,

I'm building a Core Modul on the Design on T. Close v3.

The Midi Out has strange(?) 10V. Seems incorrect to me, but I'm not in Midi-Specification. The Voltage supply of the Microcontroller and smaller Chip seems korrect (5V at all points in the introduction).

Any Idea?

Thx,

Dennis

Update:

Seems to be my fault: I just was on AC not DC. With DC I get 5V+ on both outer Pins to the Groud Pin (middle). This should be correct, or?

Additional Info:

I'm just before loading up the syx file via midi into my bootloader and don't want to blow up my [expensive] soundcard. I even ordered a cheap Midi IO Cable to go for sure now. I can use it anyway for Laptop+Synths.

[stryd_one]

5V is fine, go for it!

Additional info: I take no responsibility if I am wrong and your PC blows up! hehehe