Pedech
-
Posts
4 -
Joined
-
Last visited
Content Type
Profiles
Forums
Blogs
Gallery
Posts posted by Pedech
-
-
On 5/14/2020 at 9:16 AM, dualmono said:
Did anyone install FPGASIDs in their sammichSID?
I'm looking for replacements for my 8580s and was wondering if sammichSID would be compatible to FPGASID and if it would be possible to use one FPGASID to replace both sammichSID ICs?
And if it is possible, how to do it.Thanks!
Just did it. One FPGASID replacing both ICs. You can define using a C64 what mix of SIDs you want the Fpgasid to emulate.
I just followed the steps posted by @Fab, ignoring the mentioned control software step.
-
Just a follow up that may help someone else in the future…. it worked.
The crystal that came with my kit was a 12000 mhz while the build instructions indicates a 10000 mhz. I replaced the cristal and it worked.I had to solder it upside down in the pcb because once I took out the 12000 one, the trails were gone.
Thanks
-
I see this is an older thread. So apologies for jumping in this late...
I just built one of these ebay's new sammichSID kits. Voltages are OK, Core MIDI loopback (shorting PIC TX&RX) is a pass.... but MIOS Studio will not find the PIC. I keep getting line after line of 'ff' in the MIOS Studio MIDI input and no lucky in it finding the PIC. Have you seen this behavior anytime when you built your kit ?
2 x MB6582 / 4 x SID6581 and some more stuff
in Fleamarket
Posted
How much for a pair of SIDs? Thanks.