[MIDIbox Jam Session in Muenchen]

...ich will - ich will :thumbsup: ...

[AIN would also accept 100kOhm poti inst. of 10kOhm?]

I think that you can use the common MIOS32 driver without modifications.

The metal case of the pot should be grounded, cables to J5A shouldn't be longer than 10..20 cm, and it also makes sense to add a 100 nF cap from the middle pin to ground to filter high noise jitter.

...Thank You!!!... :thumbsup:

[AIN would also accept 100kOhm poti inst. of 10kOhm?]

...hmmm, i just realise that your answer relates to the PIC...

...is it the same with STM32 (which i plan to build as i have the parts here already :rolleyes: )...

[AIN would also accept 100kOhm poti inst. of 10kOhm?]

...hi Thorsten,

thank you for your quick and encourageing reply!...

...i did fear that it might not be as easy as to just add the 11k resistor - but then: electronics is a huge new field for me...

...i'll let you know if it works out with the un-altered joysticks - unfortunately i will not have it ready until mid october (you know :ahappy: ) to let you have a try...

cu

[AIN would also accept 100kOhm poti inst. of 10kOhm?]

...attn: electronic&MIDIbox-dummy question...i have browsed backwards to find an answer, but did not find anything suitable...

...i'd like to use a joystick as input for a MIDIbox 64 - unfortunately that joystick is just available with two 100kOhm poti installed; now i assume that the AIN-module should work with those also - in terms of: not requiring 10kOhm - but i am not sure...

...could someone either confirm that it would work (even with less accuracy) or tell me if i have to solder a 11kOhm-resistor in parallel to get almost 10kOhm?...

TIA.