greg19606

I know its been a little while since the last post, but I was wondering if there were any faders left. Thanks Greg

Good Evening, Thanks for the advice, after checking the items mentioned I ended up replaceing the of the 595's and it ended up working just fine. I must have had a few bad ones around. Sorry about taking so long to get back, classes endedup getting in the way. Thanks Again Greg Griffith

Good Afternoon, I been working on building a MBLC and can't seem to get the motor part of the faders working. The faders themselves report position to the computer but don't move when commanded. I also tried the test/calibration program and have the same result. I am using alps motorfaders but these don't have touch sensors. I have done the basic checks but I'm at school and don't have a scope or logic analyzer handy to more in depth tests. The only thing I can think of is that I dont have the touch sensor setting right, but I am not sure what the right setting would be. If anyone has any suggestions as to what I might check or adjust that would be a big help. Thanks Greg Griffith