sidmonster Posted June 14, 2011 Report Posted June 14, 2011 Hello, I've built a small controller to launch clips and such, I wanted to know if it is possible to reassign pins for my buttons and led's (not rings, just single) or do I have to stick to a default wiring? I looked through the setup.asm, but I only see that entire registers (groups of 8) are assignable, not individual pins. Would I be better off using another app? I have buttons and encoders in this project.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now