AoutLC and filter (SOLVED!)

[igi]

Hi!

I noticed one problem with controlling external filter.

I use MBsid V2 (rc38) with AoutLC (cutoff 12bits,resonance 4 bits).

Everything if working just fine, but:

For example:

(all modulations (LFO's, EG's) is turned off)

cutoff value is 0, and I hold any key pressed then cca.every 5 seconds voltage is increase for 1,25V.

(I use 0 to 5V)

When key is pressed value=0V, after 5sec. value=1,25V ,after 10sec. value=3V ... until voltage is 5V.

If I release key and press it again voltage stays on last value.

On display value is still 000.

I can set voltage to 0V again only if I move cutoff knob.

Resonance voltage is working normally.

Any ideas???

Thanks in advance and best regards,IGI

I just noticed that problem is not in Aout, because there is the same problem

with internal (SID's) filter.

SOLVED!!!!

I upload application again and.....that is this :frantics: !

Edited February 4, 2012 by igi

[TK.]

Woah! Sounds like the installation was infected by a virus! ;)

Best Regards, Thorsten.

[igi]

HI!

TK, thanks for your reply.

I check my computer, but I did not find any viruses, so I hope you are wrong. :cry:

Problem is that you are usually right!!!

I also check my room and I found mostly MIDIBOX gear and no virus! :thumbsup:

I will report If I have more problems.

Best regards, IGI

Edited February 6, 2012 by igi