Part # for Ethernet socket on LPC17 board

[portervance]

I'm hoping someone can point me in the direction of the correct ethernet port part to used with the LPC17 board on the SEQ4 project. I've purchased 2 ethernet sockets so far and neither has aligned properly to the PCB (the pin orientation is correct but some of the extra through-hole points do not align). I'm hoping to order the part via Digikey so I would appreciate if someone could point me to a specific correct part that they sell. Thank you!

[borfo]

It's a MagJack SI-60024-f - digikey #380-1117-ND

 

Make sure you get the right one - the pinouts can be pretty different on different eth jacks.  (edit: haha - rereading your post, I see you made the same mistake I did by ordering substitutes thinking the pinouts would be the same.  Mine fit the board, but I soon found out that even jacks with identical pin configurations can have different pinouts.  The SI-60024-f is the correct part.)

Edited November 11, 2014 by borfo