Bug in MB CV V1.3 (DIN Sync start/stop)

[rvlt]

I think I found a bug in the MB CV V1.3 firmware. The DIN sync start/stop output behaves incorrectly. 

 

When I press start in my DAW (Logic) the start/stop output goes high (5V), when I press stop it goes low again (0V). so far so good. But when I move the song position line in Logic (or Ableton) while it is still stopped, the start/stop output of my MB CV goes high again and stays high until I start and stop Logic again. Maybe MB CV mis-interprets Logic's SPP-commands as start commands, somehow.. don't know.

 

The DIN sync start/stop works fine on a MB 808, I just checked that.