Duggle Posted November 18, 2018 Report Share Posted November 18, 2018 Using ENC command it is possible to specify which DIN pins of which Shift Register an encoder is wired to. Is it possible to do this with buttons? You see I'm assembling a large array of encoders that have push switches, and to rationalise (neaten) the wiring I would like the encoder pins and its push switch pin to use adjacent pins on the DIN Shift Register(s). Thanks for any hints! Quote Link to comment Share on other sites More sharing options...
TK. Posted November 18, 2018 Report Share Posted November 18, 2018 No this isn‘t supported – such mapping functions are very costly, without the NGC setup might be a bit more difficult, but I think this is an acceptable compromise. Best Reagrds, Thorsten. Quote Link to comment Share on other sites More sharing options...
Duggle Posted November 18, 2018 Author Report Share Posted November 18, 2018 Thanks TK. That is understandable, It would be nice to have in this specific instance but straight forward to do without as well. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.