Jump to content

Recommended Posts

Posted

ok,

so i got AIN working and all DIN buttons work except buttons

1+2+3+4, which are needed to do the menu of course.

I doubled check my soldering but 3 of the four buttons don''t work.

Bad button? Meter test, no good button. Out of curiousity I try bypassing the buttons and shorting from ground on J3 to the individual pins on IC1 (i.e. pins  I7,I6,I5) and still no dice. This works on all 29 other buttons except these.

Perhaps a bad 74HC165? I know you can reassign the menu buttons with code but I'm at a complete loss on where and how.

I'm gettin so close to midibox meltdown.

thanks<

blood

Posted

Thorsten,

I swapped 'em and the same thing occurs. Would those 3 contacts actually send a midi message or are those MiOS exclusive ( i'm using midiox to monitor since my LCD is not working.) I should also note that the other side of that IC works.

blood

Posted

You didn't wrote which application you've used to test the DINs.

If you are using the MIDIbox64 application, then: of course, they are assigned to the menu functions. You can disable the menu buttons in main.asm by changing the pin numbers (DEFAULT_DIN_MENU_*) to >= 64

Best Regards, Thorsten.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...