MIOS BOOT STRAP PROBLEMS

[damiafix]

Hi I've a problem with boot strap loader. When I put on the core ,then the pic 18Fprogrammation with the boot strap  in the lcd screen is printed this figure :

________________________________

xxx xxx xxx xxx xxx xxx xxx xxx xxx xxx

xxx xxx xxx xxx xxx xxx xxx xxx xxx xxx

________________________________

??? ???

I try to send with MIDIOX the SysEx command: F0 00 00 7E 40 00 01 F7   ( the id is 00 of default as original boot strap hex file) but I don't have nothing signal.

I think that the core hardware is ok becouse then that  I upload in the PIC the mios1_7.hex file with JDM ,when I put on the core I see in the LCD screen the word "READY"   :P . I've replaced the 6N138 with a 6N136 with a resistor of 5.6Khom for R6 and I've sconnetted the PIN 7 of 6n136. From the MIDI OUT of COre I misure 5 volts (from the ground and the other two pins of J12 - R7 and R8 ) It's normal? I've connected the midi out and the midi IN of the COre to my Hammerdall DSP midi connection , but when I put on the core I don't recognize a midi impulse to the led midi input of my midi card. It's normal?

Thanks for your patience ,

Regards, Damiano  ;) ;)

[LO]

So you have burnt the boot strap, then loaded Mios via sysex? (not via JDM) this has then printed ready on you screen?

Now which app have you tried to upload? mb64?

[damiafix]

Hi Lo ,

thanks for your reply finally I've resolved   :D , the problem was the midi connection that was wrong  :P . Now the heart of my Midibox is pulsed !!!!! I've uploaded the OS (mios 1.7 ) and I'm starting to finish the others modules for my Nuendo Controller.  

Thanks again for your support ,

Regards, Damiano