DIN SYNC Clock [solved]

[eptheca]

Hi,

I have added a DIN SYNC out socket to my SEQ V4 

It's connected to a SR on a DOUT board, Enabled and assigned SR in the MBSEQ_HW file, and configured in the CV page.

It starts and stops my Roland TR-606, but the tempo is very uneven.

I have tried adjusting the Width in ms, but it makes no difference.

Anybody with a suggestion?

Cheers, Hal 

Edited September 5, 2023 by eptheca

[eptheca]

Does anybody know where the J5C port is?

I can't find it on the Core board, or in the schematics, but the HW config file has a setting for J5_ENABLED where DIN sync and start/stop is forwarded to J5C.

[eptheca]

Solved. My bad. Human error.

I forgot that I had wired up output 1 and 3 for convenience,  and was adjusting 1 and 2.

So now I have DIN sync clock and start/stop, and it's working fine for syncing old Roland gear.

Still haven't found J5C.....