Swiss75

Ok cooking on gas Thank you so much Antichambre

Hey Antichambre, thank you for the reply I'd really like to replace the fader for buttons if possible. From what you have sais there if i was to connect a momentary on switch to ADC and GND pressing that would mute channel B ? Regards and apologies for posting in the wrong place

Evening all, I do hope this is the right place to post this I have a Denon MCX8000 and the crossfader needs replacing, however I'd like to do away with it altogether and replace it with buttons that mute momentarily when pressed Trouble is I have no idea how to achieve this and thus i'm looking for advice/help. I did take the fader out to inspect it and noticed it only has three wires attached so in theory it'd be a ground and A and B? Closing the ground to either A or B would work? or would I need a resistor too? or am I completely wrong? Thank you for reading Best Tony

Yes old chap just went over the board searching for wrong deeds I'd missed a few soldering points on two of the RAs and one resistor Have just soldered and tested and all is working. This has made my week

Encoder no5 seems to send the display into meltdown and ends with the display reading 'no songs available as long as the session hasn't been created Please EXIT and create a new session!' Will it have something to do with the datawheel encoder and leds currently not being soldered on

If there's no interest in the other parts I'd like to have them

Excellent. Cheers sir

Afternoon all I'm considering getting the v4 boards from modular addicts and am unsure whether the midiphy midi boards would work with the older core board Would I have to get the ones from addicts or will the midiphy ones work?

Cheers jaytee Good idea latigid, how much would you want for the board you mentioned

A new board is 10 pounds...I'll take my.mistake on the chin and go again

here we go, two of the pads have lifted, this is the best pic I can get at this time of night I'm afraid https://imgur.com/a/NldOc3t

Haha yes rotated the wrong way, I'll upload a photo now and if anyone mocks my poor soldering i'll not be happy

Just killed a wcore board trying to remove an upside down smt chip Will be pacing the room until the 9th

Is the case only available to buy as a whole unit ?

Cheers Phil, yeah I didn't think it was gonna be easy or cheap but i'd thought i would ask on here just in case