stereo sid on veroboard

[n0zem]

Okay i'm taking the challenge

I haven't got any experience with electronics (As the matter of fact the last time i hold an solderering iron was when i was 10 years old and it was to make a fancy thing with coloured glass)

but i want to make a stereo midibox sid on one veroboard so the core module both sid modules a dx2 module and a couple of banksticks, i'm pretty sure someone has done this before but i can't find any info.

so any advice is welcome. I will probably get everything done without advice but the less it looks like a plate of spaghetti in the end the better :)

to get a bit of experience i will first built a pic burner (it's cheaper to buy an unburned pic and the parts for a burner than to buy one from smash with their shipping rates)

I know it's perhaps a bit ambitious but hell what's live without a challenge

n0zem

[nILS]

Wekcome aboard n0zem! :flowers:

The best thing you can do is to plan. Then check the plan and replan, ... There's been a few veroboard version (Pascal made an mb6582 on veroboard for instance) but they're usually not documented all that well. Start with the PSU section, check the voltages, do the core sections, get them up and running do the sids, run all the test, whee :)

Good luck with the project!