runinit Posted April 20, 2010 Report Share Posted April 20, 2010 Hi everyone! I've finally finished the layout of my Midibox. It's going to be used mostly for Ableton Live. Enjoy the pics :) Overview.. Left: 8x8 Livid Pads - Going go to have Bicoloured LEDs (The boards only have 2 holes for the LEDS :() 8 x Icecube Buttons 8 x Pots for volume on 8 tracks Middle: Faders and buttons all around :) Encoder and buttons for LCD Control Right: 16 encoders with LED rings. 20x2 LCD Xfader I still need to add some more buttons for transport control near the bottom, but this is pretty much it :) Any suggestions? Quote Link to comment Share on other sites More sharing options...
findbuddha Posted April 20, 2010 Report Share Posted April 20, 2010 The bicolor LED issue has discouraged me from using any of the pre-made button pad PCBs - how do you plan to overcome this? :) Quote Link to comment Share on other sites More sharing options...
runinit Posted April 20, 2010 Author Report Share Posted April 20, 2010 The bicolor LED issue has discouraged me from using any of the pre-made button pad PCBs - how do you plan to overcome this? :) I found some that have two leads. So hopefully i'll be able to hack that in, if not i'm going to drill out current holes and build a daughter board. It's quite excessive to build a secondary board just for LEDs (and if i did that I would use RGB). http://ca.mouser.com/ProductDetail/Kingbright/WP937EGW/?qs=sGAEpiMZZMs4quMj8r4lmn9toQ0TRIokqvXtkDU8gN8%3d Quote Link to comment Share on other sites More sharing options...
ultra Posted September 18, 2010 Report Share Posted September 18, 2010 what kind of case were you going to put this panel in? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.