LED Resistors for Wilba's PCB

[lukas412]

I assume the voltage at the led's on Wilba's sequencer pcb will be 5 volts but want to double check to be sure. I just want to test some various resistors to get the right brightness before I solder.

Thanks,

Luke

Edited February 2, 2012 by lukas412

[kHz-tone]

Do not solder resistors to PCB, use sockets, so you can test different values.

cheers

Philipp

Edited February 1, 2012 by kHz-tone

[findbuddha]

Yes, 5 volt, but make sure you test using the PCB (not just a breadboard) as the matrix wiring reduces the brightness a bit.

[lukas412]

great thanks so much guys!