Global MIDI Channel

[Duggle]

I'm loading an alternative NGC with all controls set to channel 2: 

here's an example:

EVENT_ENC id= 5 hw_id= 5 fwd_id=LED_MATRIX:25 bank=1 fwd_to_lcd=1 chn=2 type=CC range=0:127 offset=0  ports=1000010000000000 led_matrix_pattern=3 cc=40  syxdump_pos=1:40 label="^Fil1Freq"

I'm only seeing events on channel 1 on MiosStudio as well as the synth and also on midibox SCS midimontor. 

My first thought was the channel is being overridden by a global setting but the manual says this feature is not implemented yet. Has anyone noticed this issue? 

[Zam]

Hi Duggle

How is you hardware connected to your host computer ? it look like USB and I suspect the channel 1 you actually see at MiosStudio is USB1.

Your port definition send to USB1 en MIDI2

To monitor MIDI2 you have to connect the respective DIN5 MIDI connector (via a midi interface) and select the appropriate midi in port at MiosStudio (or any other midi host software)

If you want to use USB1 and USB2 the ports configuration is ports=1100000000000000

Best

Zam

 

[Duggle]

I'm talking about MIDI events channel number, not ports.

In the config, as shown above, the  CC should happen on midi channel 2, but its seen to be on channel 1.  

[Zam]

Ho sorry my bad...

Any router configuration?

If it's an alternative .NGC don't forget to add a reset_hw command at start

Best

Zam

[Duggle]

 

On 02/01/2017 at 6:49 AM, Zam said:

Any router configuration?

Hi, thanks, yes there is:

 ROUTER n= 1   src_port=IN1   src_chn=17 dst_port=OUT2  dst_chn=17
 ROUTER n= 2   src_port=IN2   src_chn=17 dst_port=OUT1  dst_chn=17
 ROUTER n= 3   src_port=IN3   src_chn=17 dst_port=OUT4  dst_chn=17
 ROUTER n= 4   src_port=IN4   src_chn=17 dst_port=OUT3  dst_chn=17
 ROUTER n= 5   src_port=USB1  src_chn=17 dst_port=OUT2  dst_chn=17
 ROUTER n= 6   src_port=IN2   src_chn=17 dst_port=USB1  dst_chn=17

Nodes 5 and 6 are the only ones that are important at the moment. The value 17 means all channels passed and none translated IIRC.....

[Duggle]

OK, I've stripped the alternate ngc to the absolute minimum:

RESET_HW
LCD "%C"
ENC n=1 sr=5 pins=0:1 type=non_detented 
EVENT_ENC id= 1 hw_id= 1 fwd_id=LED_MATRIX:17 bank=1 fwd_to_lcd=1 chn=2 type=CC range=0:127 offset=0  ports=1000010000000000 led_matrix_pattern=3 cc=17 offset=-64 syxdump_pos=1:17 label="^Osc1Shp"

Encoder #1 outputs data on CC#17 on channel 1.

Any help appreciated.