macsaif

AINSER parallax mode

2 posts in this topic

Hello,

 

I am trying to understand the parallax mode of AINSER. I would like to use it, but in my case it works exactly as DIRECT function.

In NGC I am configuring the AINSER and the forwarded 2 SENDERs:

 

AINSER n=1 enabled=1 muxed=1 cs=1 resolution=7bit pinrange=3:10:4055

EVENT_AINSER id=3 hw_id=3 fwd_id=SENDER:3 range=0:127 no_dump=1 ain_mode= Snap

EVENT_SENDER id=3 hw_id=3 type=CC chn=1 cc=43 range=0:127 no_dump=0 ports=1111110000000000

EVENT_SENDER id=103 hw_id=3 type=CC chn=4 cc=43 range=0:127 no_dump=0 ports=1111110000000000

 

Based on the actual status of one button in .NGR I am activating Sender 3 or Sender 103 and copying its value back to AINSER.

It works correctly with SNAP function but if I change the SNAP to Parallax it jumps directly to the actual status of the potentiometer when I move with it (like the direct mode).

Can it be connected with the think that the AINSER works in range 0-4065 and the CC works in range 0-127?

What is a correct solution?

Frank

Share this post


Link to post
Share on other sites

Nobody uses the Ainser in Parallax mode eith succes? 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now