kokoon Posted December 8, 2006 Report Share Posted December 8, 2006 where could one buy a polypropolene rod? Quote Link to comment Share on other sites More sharing options...
Mr modnaR Posted December 8, 2006 Report Share Posted December 8, 2006 where do you live?http://rswww.com do it. Quote Link to comment Share on other sites More sharing options...
kokoon Posted December 10, 2006 Report Share Posted December 10, 2006 i live in slovenia... :-\ Quote Link to comment Share on other sites More sharing options...
Mr modnaR Posted December 10, 2006 Report Share Posted December 10, 2006 rswww.com have a slovenian website:http://www.rs-components.at/hope that helps. Quote Link to comment Share on other sites More sharing options...
Dolphinicus Posted December 10, 2006 Report Share Posted December 10, 2006 Thanks for mentioning that the sanded Acrylic tending to become more clear with finger oil! :o :o I was going to go out to a local plastics supplier this week to GET a rod, for my buttons. Now - I'll be asking them about a polypropylene rod. :) Great looking buttons from your end! :)I'll need one big enough for 5mm LEDs though, if I do the inside drilling bit. No troubles. :) Quote Link to comment Share on other sites More sharing options...
DrBunsen Posted January 4, 2007 Report Share Posted January 4, 2007 Verowire is expensive ... it only took 1/3 of the time to wire a complete board, since it was not required to deisolate the cables with a cutter - just heat up the isolation :)You could strip an electric motor and use the winding wire Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.