vodoux Posted March 26, 2007 Report Share Posted March 26, 2007 hi, I build a Step A control surface for my sid with push buttons. Everything is working fine except that half the time I push my increase or decrease button, the value increase (or decrease) by more than one... usually two and sometimes three. Is there a parameter I didn't see in my .asm file that can fix this or is it just because I have cheap push button?thanks Quote Link to comment Share on other sites More sharing options...
doc Posted March 26, 2007 Report Share Posted March 26, 2007 Normally the buttons are debounced by software.There are more possibilitys than bad knobs. If I remember right there is a value to change the debounce behaviour.Have a look in the source code...maybe you'll find it.You also can try to debounce a bad knob with a resistor and a small cap (10 ..100 nF).greetsDoc Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.