EA LPC1769 Revision

Great illustration of revision difference . Maybe a 'twisted' pin could fill the 1.27mm gap pinout difference ?

Edited September 16, 2016 by Psykhaze

Why three times the same image?

He told previously about uploading problems with new forum.
By the way old galleries don't show photos anymore,at least by my side

Edited September 16, 2016 by Psykhaze

Will be difficult because, headers on the core are too high no enough space to bend the pins.

You can solder wires(I keep cutted resistor legs for that) on the pins which are used in your app. Think about the bootstrap pin too.

But it's not a good solution, for the raison you can imagine.

Fortunately Lextronic always have a stock of rev B.

 

Yea sure, was just a wondering. For reference here is current Lextronic Link : http://www.lextronic.fr/P19864-module-lpc1769-lpcxpresso-board.html

Yes picture upload problem, sorry for that.

no way to delete It too, no option except "édit details" in manage picture button.

Seems I'm not the only one: 

 

 

Hi!

It's possible to bend the pin to make them match the MBHP PCB, that's what I did. But I think it's better if you can get a rev B!

You can find some pictures of my bending here : http://midibox.org/forums/topic/18552-lpc1769-rev-c-different-layout-than-rev-ab/?page=2#comment-167161

Yep! you remove the plastic after solder, of course.

Yes ;) Actually I noticed it didn't fit after I soldered the pin headers... So I removed the plastic, and bend the pins.