Jump to content

SparkFun ButtonPad PCB for MIDIbox64


Recommended Posts

Posted

Woop! Thanks for letting me know!

It's a good job because I just went and photoshopped up a circuit board for it (based off Exported Eagle images, so should be to size etc). See attached.

For all you DIY Etches, is this going to be possible, or are the tracks too fine? Theres room to make them bigger really, so I could do that. IF DIY is possible, I was going to head down the route of Laser Printer, would this be ok, if not tedius? Or should I really be looking at exposing the boards?

Thanks for all your help guys/girls! I'm starting to see the end of the tunnel.

Christian

5731_2b7771aa0ff2080f75226a7cd11d2b3a810

5731_2b7771aa0ff2080f75226a7cd11d2b3a810

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...