Center the two audio channels

[DaShad0w]

The manual reads this at the Multi engine disadventages:

in most cases it's better to center the two audio channels (especially in poly mode) - stereo sounds can only be realized by using two instruments and assigning them to specific voices (-> see CFG page), but the Lead Engine provides more sophisticated functions for stereo effects!

Does anyone know to best way to center the 2 audio channels so that i do not hear osc 1,2,3 (receiving MIDI at channel 1) at left and osc 4,5,6 (receiving MIDI at channel 2) at right?

Thanks in advance.

regards,

Ronald

[seppoman]

Yes - use a mixer ;) or if it's connected to a DAW software, setup two mono channels using only left in and right in as an input, so you can pan them independently.

[Imp]

Just sum up the left and right channel to one mono-channel.

You can do this without any active circuitry. Just tie the outputs togethter.

A pluggable stereo to mono adapter, or Y-cable does the trick.

[DaShad0w]

Ok thanks!

I am going to try it :)

[Antix]

Hi,

It is not a good thing to short two or more audio source brutally.

Better with resistors - more better with resistor and OpAmp ( adder configuration )

in few words a mixer.

Regards

Antix

[DaShad0w]

My first try was going to be the mixer :)

[DaShad0w]

thanks guys! it works.

I have used 2 channels on my mixer :)