Jump to content

AOUT NG : only half expected voltage in bipolar


Recommended Posts

  • 3 years later...
  • 3 weeks later...

Last month illogik built my redesigned AOUT module and found some bugs in the PCB. While discussing possible solutions we came to the conclusion that it's probably much easier to have the AOUT only output unipolar 0 to 10 volt, and design a simple -5v level shifter board that can be used as an add-on (or separate module with hands-on access to the level shifting) to shift the output to -5 to +5 volt where needed.

 

Things to consider are:

- not a lot of equipment actually makes use of negative voltages

- equipment that needs bipolar CV input can be retrofitted with a fixed level shifter at the input to make it compatible with your other modules

- negative voltages can be used for CV modulation purposes (modulate one CV source with another) so it's certainly not useless

  • Like 1
Link to comment
Share on other sites

Here is a different approach: inverting amp followed by an inverting mixer/unity gain buffer with switchable +5V offset

 

gallery_5453_5_51028.png

 

 

Two more op amps but probably a better design decision. A positive/negative voltage swing is often used to sweep above and below a set control e.g. an LFO modulating a filter frequency. As the new MBCV application will generate LFOs I think full scale CVs are still widely applicable.

 
 
Edited by latigid on
Link to comment
Share on other sites

Two comments:

 

1. Do I see correctly that you take the +5v to shift the levels from the power rail? Is that precise enough? Maybe adding a precision reference is a better idea?

2. I would like to see the level shifter as a separate PCB, so MAX AOUT users could also benefit from it.

 

I agree with the usefulness of full scale CV for modulation purposes, like I wrote earlier :thumbsup:

Link to comment
Share on other sites

No, I have an offset wired from the +12 V buss, divided through a trimmer. The offset is mixed through an op amp summer, so load changes shouldn't be too much of an issue. This also uses a more stable inverting amplifier that needs to be inverted again for correct signal phase/polarity. The perfect place to introduce an offset voltage!

 
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...