Lamouette

modulable SEQ and BLM (separate)

4 posts in this topic

HI all,

I have a question, i recently add my name on the SEQV4 bulk order, and after i will build it, i would to built a BLM, but i have a question :

Do you think i's possible to separate the BLM like a plug: for exemple when you want to use your SEQV4 without BLM you just unplug a box with the BLM and you could use the SEV4 "alone", and if you want you "re-plug" the BLM and you could use like normal SEQV4 and BLM.

I'm sorry for my bad english, but i hope you will understand my question !

Thanks and bye all !

Edited by Lamouette

Share this post


Link to post
Share on other sites

This is already possible, as the BLM is connected to SEQ via MIDI.

(I'm not sure if it's possible to hot-plug, you may need to reboot SEQ)

Share this post


Link to post
Share on other sites

ok ! nice ! i'm quite impatient that i could build my own SEQV4 !

Share this post


Link to post
Share on other sites

It is possible to separate the BLM from MBSEQ with a plug, I'm doing this as well! :)

See the socket at the right side of the rear panel:

mbseq_case32.jpg

Here the schematic for the 8-pin connector:

http://www.ucapps.de/midibox_blm/blm_connector_mbseq.pdf

The BLM can be connected/disconnected during runtime and will be automatically detected, no need to reboot the sequencer.

Best Regards, Thorsten.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now